Transmission Washer Options
For StingRay Transmission WASHER:

Transmission WASHER Productivity
Automatic Lubrication System
Chip Baskets
Closed Loop Rinse System
Hand Rinse Wand
High-Low Pressure Switch
High Output Electric Heat
Hour Meter
Remote Grease Lubrication Points
Rinse Rust-Inhibtor Injector System
Pump Amp Meter
Pump Upgrades
Turntable Capacity
Turntable Jog

Transmission WASHER Configuration
50 Hz Engineered System
Auto Steam Exhaust
Center Manifold Probe
Heat Source- Gas, Electric, Steam
Heavy Duty Duplex Pump
High Speed Evaporation Drying
Hot-Air Blow-Off
Gas Burner Option
Pump Pressure Regulator
Short High Impact Manifold (Video)
Stainless Steel Cabinet
Stainless Steel Heat Exchanger
Stretched Work Height Mild Steel
Stretched Work Height Stainless Steel
World Model

Transmission Parts Washer
Solution Management
In-Line Filtration
Oil Coalescing System
Oil Skimmers
Sludge Pump Cart
Sludge Scraper
Solution Transfer Pump

Transmission WASHER Safety
Cabinet Noise Reduction Insulation
Chemical Spill Containment Pan
Industrial Control & Safety Disconnect
Internal Reservoir Cover
Pump Sound Barrier

Transmission Parts Washer
Material Handling
Parts Cleaning Baskets
Parts Cleaning Fixtures
Parts Cleaning Tie-Down Ratchet Strap
Parts Loading Jib Crane
Turntable Anchoring Attachments

Transmission Parts Washer
Energy Conservation
Cabinet Thermal Insulation
Internal Reservoir Cover

Transmission Parts Washers

Stingray Aqueous Parts Washer Results on Transmissions

Transmission rebuilding requires precision cleaning of the transmission's external and internal parts. Gears, shafts and casing must be cleaned for inspection and repair prior to reassembly. The automatic StingRay solvent free parts washer is a great tool for saving time and improving your transmission remanufacturing, repair and rebuilding shop. Place the transmission parts in the washer, start a cleaning cycle and come back in 15 minutes for parts that are contamination free and dry. Pre-cleaning the complete transmission takes only minutes in the aqueous parts washer. Pre-cleaning prevents the migration of grease and oil into the rest of the shop and makes disassembly easier as all bolts are readily accessible. After disassembly the case, pan and all gears, shafts, nuts and bolts can be quickly cleaned in baskets in the aqueous washer. A 15 minute wash at 180 degrees F (82 C) removes all road soils, grease, and grime on all the parts. Power Kleen IIIL detergent is safe for aluminum as well as all metals and rinses well leaving no residue. A rust-inhibitor injector pump on the hot fresh water rinse system prevents corrosion and flash rust on the parts after cleaning leaving amply protection time for re-assembly.

The StingRay power wash system and the unique oscillating blast system assures cleaner parts. Saves time and money by reducing cleaning time so your rebuilders can earn money rebuilding instead of cleaning transmission parts. The photos below demonstrate the incredible cleaning efficiency of the StingRay aqueous transmission washer.